| Patent Number |
Title Of Patent |
Date Issued |
| 4088853 |
Ignition distributor-breaker structure for internal combustion engines |
May 9, 1978 |
| To reduce the axial length of distributor-breaker assemblies and to provide for reliable placing of a second upright bearing for the distributor shaft, a holding plate to which a bearing is floatingly attached is clamped in the distributor housing by means of a claw clamp, tightened by |
| 4075752 |
Method of making distributor assembly bearing structures and the like |
February 28, 1978 |
| To prevent corrosion and provide for better relative movement of parts which move only slightly but are exposed to extremes in ambient operating conditions, a tubular piece of plastic material, typically Polyvinylidenfluoride or a polyamide, is drawn over the inner element of a relat |
| 4071792 |
Engine ignition timing signal generator having a reduced number of permanent magnets |
January 31, 1978 |
| Four pole pieces embedded in the cylindrical periphery of a non-magnetic rotor disk are connected with each of a number of magnets embedded in the disk in circumferentially distributed positions spaced from the rotor shaft and from the disk periphery. Of these pole pieces, one circum |
| 4033315 |
Ignition distributor construction for internal combustion engines |
July 5, 1977 |
| To provide an easily manufactured ignition distributor in which two bearings support the distributor shaft, the lower bearing is molded or otherwise secured into the housing structure, whereas the upper bearing is supported on a transversely extending support member, typically a support |
